The effects and annual losses attributed to electrostatic discharge (ESD) are estimated to run into the billions of dollars just in the electronics industry alone. To control the static charge, FLEXCO combines conductive or dissipative vinyl tile with a specially formulated conductive adhesive. This creates a conductive pathway which allows the static to flow through the tile and along the adhesive to the ground point. That makes FLEXCO ESD static control vinyl flooring an effective first-choice solution to control unwanted human body voltage in areas where mobility cannot be restricted by wrist straps. May contribute to LEED CI and NC credits MR 4.1, MR 4.2, MR 5.1, MR 5.2, MR 6.

FEATURES AND BENEFITS
To meet specific application requirements, FLEXCO offers static control flooring in two standard electrical resistance ranges: conductive vinyl tile with an average pointto- ground electrical resistance of 2.5 x 104 to 1.0 x 106 ohms, and FLEXCO static dissipative vinyl tile with a range of 1.0 x 106 to 1.0 x 108 ohms. Static propensity is less than 5 volts for conductive and less than 20 volts for static dissipative tile. Each tile is tested by FLEXCO to guarantee electrical performance before packaging.

+ Lifetime conductivity warranty.
+ Provides static control throughout the entire work environment.
+ Passive system requires minimal routine monitoring.
+ Conductive properties are incorporated into the tile.
+ Comes in attractive, random patterns and a variety of colors.
+ Contains an antimicrobial that resists bacteria and fungi when tested in accordance with ASTM G 21.
+ May be seamlessly installed with FLEXCO’s Vinyl Welding Beads for clean rooms and areas that have strict requirements for added hygiene.
+ Flexible to conform to subfloor irregularities and to accommodate flash coving.
+ Exceeds ADA recommendations for slip resistance on flat surfaces.
+ Resists indentation and performs under heavy rolling loads up to 2,000 psi.
+ Resists wear, abrasions, solder and many common chemicals.
+ No floor finishing required. Higher luster is achieved by buffing – no waxing.
+ Meets or exceeds all ESD control standards when tested by ASTM F 150, NFPA 99, ESD S7.1 and UL 779.
+ Does not release carbon particles into the air.
+ Uses solvent-free epoxy adhesives and is DOP (dioctyl phthalate) free.
+ Dense, homogeneous solid vinyl tile composition meets ASTM F 1700 and makes floor maintenance easier.
+ Static decay less than 0.01 second per Federal Test Method 101C, Method 4046 at 15% Relative Humidity.
+ One gallon of adhesive included for every 175 sq. foot of tile purchased, as well as 1-18" piece of copper foil for grounding.